If Your Layout Has Any Switches or Turnouts, Then You NEED To Read This!

This is for any layout that has a turnout more than 1 foot from the front of the layout.

       ANE of Taiwan has introduced the first "Turnout Controller" that solves almost every problem you have ever encountered when you try to automate your turnouts.

1. Have you ever mounted a turnout motor and not had enough room?

PROBLEM SOLVED - The ANE "SmartSwitch" is less the 1/4 the size of it nearest competitor.

2. Have you ever mounted a turnout motor a little off center?

PROBLEM SOLVED - The ANE "SmartSwitch" can be adjusted electronically so that the left and right limits are properly aligned with proper pressure against the switch point.

3. Have you ever used  turnout controlled that can't be operated by either DCC, push button or toggle switch?

PROBLEM SOLVED - The ANE "SmartSwitch can use a push button or toggle switch right out of the box and you can add a very inexpensive stationary decoder that receives it's signaling via the tracks OR "Loco Net" connection.

4. Has your old "Stall" type turnout motor over heated while "Stalled"?

PROBLEM SOLVED - The ANE "SmartSwitch" doesn't use a "Stall Drive" motor.  It is designed with a real servo motor that only goes as far as the digital command tells it to go.

5. Have you ever wished you could choose the speed that the turnout motor moves at?

PROBLAM SOLVED - The ANE "SmartSwitch" is programmable to move at nine different speeds.

6. Have you ever wished you could control how far the switch moves instead of having to settle with driving it to the "Stall" position where it can overheat (to say nothing of wasting power)?

PROBLEM SOLVED - The ANE "SmartSwitch" is programmable so that you can stop the switch movement (on a dime and get 9 cents back).

7. Have you ever had a problem with reliable power routing to the "frog"?

PROBLEM SOLVED - The ANE "SmartSwitch" has a simple inexpensive add on called the "SmartFrog" that solves the frog power routing problems forever.

8. Have you ever tried to run power for signaling from a "Stall" turnout devise with out having to glue an additional micro switch to the "Green" monster?

PROBLEM SOLVED - The ANE "SmartSwitch" has two powered terminals for signaling for each turnout.

For more technical information click Here

DGS