Train Addiction Help Line: 1.866.840.7777

Tam Valley Depot - All Scales - DCC - Micro Switch Machine without Snap Switch (SKU 7040-MSW002)

Available On: April 1, 2019

Tam Valley Depot

The Turtle is stall motor driver designed to run turnouts. It can be used with a number of popular stall motors including the TortoiseTM, SwitchMasterTM, the MP1, MP5, CobaltTM as well just about any 3-12V geared motor. It uses the TVD Fascia Controller for local control and DCC for remote control. It can also be powered with DC if the DCC control is not needed

Uses the Fascia Controller for local control and M-F jumper wires for wiring the motor.  Unique features, speed trim pot, fascia controller, 1 Amp drive current (can wire an entire double crossover off of one board), local controller DCC lockout (address+1). 

 

 

 

icro Switch Machine w/ Snap Switch

For use with Octo III, , Micro Singlet, Singlet II+, SwitchWright, Quad-PIC, Quad-LN or other RC servo compatible board


The Micro Switch Machine is based on the SG90 servo. This version does not have the snap switch mounted saving you money if you have another way to power the frog or you don't need powered frogs. The wire actuator is already mounted for you.  The Micro Switch Machine is ready to go.  Comes with a piece of double-sided foam tape for ease of mounting as well as 3 #4x1/2" screws for permanent mounting. Use with any of your servo decoders to power a turnout.

Comes with foam tape and screws for mounting under the layout.







$14.95 US
Country of Origin: United States