The fortunes of the Delaware & Hudson had been built on anthracite but by the early 1970s, anthracite traffic was but a memory and this group of hoppers was assigned for loading ilmenite tailings in Tahawas, New York likely for delivery to processors in New Jersey and Missouri. Ilmenite is the ore from which titanium is produced. We are including “ilmenite” loads for this run.

A 2-bay hopper design with offset sides was first proposed in the 1920s and first appeared in the form seen here in 1934. The AAR adopted it as a standard design the following year. The offset design permitted greater interior capacity than a rib side car with the same outside dimensions. It was thought this more than made up for the car’s higher cost of construction. The last new 2-bay offset side hoppers were built in 1960. 

These ready-to-run cars will feature:

• diecast slope sheet-hopper bay-center sill assembly
• injection molded plastic sides, ends, and hopper doors
• fully molded brake tank, valve and air lines
• body mounted brake hose detail
• coal load
• lever-style hand brake
• body mounted magnetically operating knuckle couplers
• close coupling
• Fox Valley Models metal wheels

All road names will be available in multiple road numbers. For instance, order a single, a 2-pack and a 3-pack to get all six road numbers on a run. (Some road names will be available in just three road numbers.)